Command Reference Guide

LLDP (802.1AB) Commands
CLI Command Reference
September 2014 Page 455
HP Moonshot Switch Module CLI Command Reference
lldp transmit-mgmt
Use this command to include transmission of the local system management address information in the
LLDPDUs. This command ca be used to configure a single interface or a range of interfaces.
no lldp transmit-mgmt
Use this command to include transmission of the local system management address information in the
LLDPDUs. Use this command to cancel inclusion of the management information in LLDPDUs.
lldp notification
Use this command to enable remote data change notifications on an interface or a range of interfaces
.
no lldp notification
Use this command to disable notifications.
lldp notification-interval
Use this command to configure how frequently the system sends remote data change notifications. The
interval parameter is the number of seconds to wait between sending notifications. The valid interval range
is 5-3600 seconds.
Format
lldp transmit-mgmt
Mode Interface Config
Format
no lldp transmit-mgmt
Mode Interface Config
Default disabled
Format
lldp notification
Mode Interface Config
Default disabled
Format
no lldp notification
Mode Interface Config
Default 5
Format
lldp notification-interval interval
Mode Global Config