Command Reference Guide

LLDP (802.1AB) Commands
CLI Command Reference
September 2014 Page 458
HP Moonshot Switch Module CLI Command Reference
The table contains the following column headings:
show lldp remote-device
Use this command to display summary information about remote devices that transmit current LLDP data to
the system. You can show information about LLDP remote data received on all ports or on a specific port
.
Term Definition
Interface The interface in
unit/slot/port format.
Transmit Total Total number of LLDP packets transmitted on the port.
Receive Total Total number of LLDP packets received on the port.
Discards Total number of LLDP frames discarded on the port for any reason.
Errors The number of invalid LLDP frames received on the port.
Ageouts Total number of times a complete remote data entry was deleted for the port because the
Time to Live interval expired.
TVL Discards The number of TLVs discarded.
TVL Unknowns Total number of LLDP TLVs received on the port where the type value is in the reserved
range, and not recognized.
TLV MED The total number of LLDP-MED TLVs received on the interface.
TLV 802.1 The total number of LLDP TLVs received on the interface which are of type 802.1.
TLV 802.3 The total number of LLDP TLVs received on the interface which are of type 802.3.
Format
show lldp remote-device {unit/slot/port | all}
Mode Privileged EXEC
Term Definition
Local Interface The interface that received the LLDPDU from the remote device.
RemID An internal identifier to the switch to mark each remote device to the system.
Chassis ID The ID that is sent by a remote device as part of the LLDP message, it is usually a MAC
address of the device.
Port ID The port number that transmitted the LLDPDU.
System Name The system name of the remote device.