Command Reference Guide

Network Interface Commands
CLI Command Reference
September 2014 Page 46
HP Moonshot Switch Module CLI Command Reference
show network
This command displays configuration settings associated with the switch's network interface. The network
interface is the logical interface used for in-band connectivity with the switch via any of the switch's front panel
ports. The configuration parameters associated with the switch's network interface do not affect the
configuration of the front panel ports through which traffic is switched or routed. The network interface is
always considered to be up, whether or not any member ports are up; therefore, the
show network command
will always show Interface Status as
Up.
Format
show network
Modes •Privileged EXEC
• User EXEC
Term Definition
Interface Status The network interface status; it is always considered to be up.
IP Address The IP address of the interface. The factory default value is 0.0.0.0.
Subnet Mask The IP subnet mask for this interface. The factory default value is 0.0.0.0.
Default Gateway The default gateway for this IP interface. The factory default value is 0.0.0.0.
IPv6 Administrative Mode Whether enabled or disabled.
IPv6 Address/Length The IPv6 address and length. This field is visible only if the IPv6 administrative
mode is enabled.
IPv6 Default Router The IPv6 default router address. This field is visible only if the IPv6
administrative mode is enabled.
Burned In MAC Address The burned in MAC address used for in-band connectivity.
Locally Administered MAC
Address
If desired, a locally administered MAC address can be configured for in-band
connectivity. To take effect, 'MAC Address Type' must be set to 'Locally
Administered'. Enter the address as twelve hexadecimal digits (6 bytes) with a
colon between each byte. Bit 1 of byte 0 must be set to a 1 and bit 0 to a 0, i.e.
byte 0 should have the following mask 'xxxx xx10'. The MAC address used by
this bridge when it must be referred to in a unique fashion. It is recommended
that this be the numerically smallest MAC address of all ports that belong to
this bridge. However it is only required to be unique. When concatenated with
dot1dStpPriority a unique Bridge Identifier is formed which is used in the
Spanning Tree Protocol.
MAC Address Type The MAC address which should be used for in-band connectivity. The choices
are the burned in or the Locally Administered address. The factory default is to
use the burned in MAC address.
Configured IPv4 Protocol The IPv4 network protocol being used. The options are bootp | dhcp | none.
Configured IPv6 Protocol The IPv6 network protocol being used. The options are dhcp | none.
DHCPv6 Client DUID The DHCPv6 client’s unique client identifier. This row is displayed only when the
configured IPv6 protocol is DHCP.
IPv6 Autoconfig Mode Whether IPv6 Stateless address autoconfiguration is enabled or disabled.