Command Reference Guide

LLDP-MED Commands
CLI Command Reference
September 2014 Page 463
HP Moonshot Switch Module CLI Command Reference
lldp med transmit-tlv
Use this command to specify which optional Type Length Values (TLVs) in the LLDP MED set will be transmitted
in the Link Layer Discovery Protocol Data Units (LLDPDUs) from this interface or a range of interfaces.
no lldp med transmit-tlv
Use this command to remove a TLV.
lldp med all
Use this command to configure LLDP-MED on all the ports.
lldp med confignotification all
Use this command to configure all the ports to send the topology change notification.
Default By default, the capabilities and network policy TLVs are included.
Format
lldp med transmit-tlv [capabilities] [ex-pd] [ex-pse] [network-policy]
Mode Interface Config
Term Definition
capabilities Transmit the LLDP capabilities TLV.
ex-pd Transmit the LLDP extended PD TLV.
ex-pse Transmit the LLDP extended PSE TLV.
network-policy Transmit the LLDP network policy TLV.
Format
no lldp med transmit-tlv [capabilities] [network-policy] [ex-pse] [ex-pd]
Mode Interface Config
Format
lldp med all
Mode Global Config
Format
lldp med confignotification all
Mode Global Config