Command Reference Guide

LLDP-MED Commands
CLI Command Reference
September 2014 Page 464
HP Moonshot Switch Module CLI Command Reference
lldp med faststartrepeatcount
Use this command to set the value of the fast start repeat count. [count] is the number of LLDP PDUs that will
be transmitted when the product is enabled. The range is 1 to 10.
no lldp med faststartrepeatcount
Use this command to return to the factory default value.
lldp med transmit-tlv all
Use this command to specify which optional Type Length Values (TLVs) in the LLDP MED set will be transmitted
in the Link Layer Discovery Protocol Data Units (LLDPDUs)
.
no lldp med transmit-tlv
Use this command to remove a TLV.
Default 3
Format
lldp med faststartrepeatcount [count]
Mode Global Config
Format
no lldp med faststartrepeatcount
Mode Global Config
Default By default, the capabilities and network policy TLVs are included.
Format
lldp med transmit-tlv all [capabilities] [ex-pd] [ex-pse] [network-policy]
Mode Global Config
Term Definition
capabilities Transmit the LLDP capabilities TLV.
ex-pd Transmit the LLDP extended PD TLV.
ex-pse Transmit the LLDP extended PSE TLV.
network-policy Transmit the LLDP network policy TLV.
Format
no lldp med transmit-tlv [capabilities] [network-policy] [ex-pse] [ex-pd]
Mode Global Config