Command Reference Guide

LLDP-MED Commands
CLI Command Reference
September 2014 Page 467
HP Moonshot Switch Module CLI Command Reference
Extended POE
Device Type: pseDevice
Extended POE PSE
Available: 0.3 Watts
Source: primary
Priority: critical
Extended POE PD
Required: 0.2 Watts
Source: local
Priority: low
show lldp med remote-device
Use this command to display the summary information about remote devices that transmit current LLDP MED
data to the system. You can show information about LLDP MED remote data received on all valid LLDP
interfaces or on a specific physical interface.
Example: The following shows example CLI display output for the command.
(Routing) #show lldp med remote-device all
LLDP MED Remote Device Summary
Local
Interface Remote ID Device Class
--------- --------- ------------
1/0/8 1 Class I
1/0/9 2 Not Defined
1/0/10 3 Class II
1/0/11 4 Class III
1/0/12 5 Network Con
Format
show lldp med remote-device {unit/slot/port | all}
Mode Privileged EXEC
Term Definition
Local Interface The interface that received the LLDPDU from the remote device.
Remote ID An internal identifier to the switch to mark each remote device to the system.
Device Class Device classification of the remote device.