Command Reference Guide

Network Interface Commands
CLI Command Reference
September 2014 Page 47
HP Moonshot Switch Module CLI Command Reference
Example: The following shows example CLI display output for the network port.
(Routing) #show network
Interface Status............................... Up
IP Address..................................... 0.0.0.0
Subnet Mask.................................... 0.0.0.0
Default Gateway................................ 0.0.0.0
IPv6 Administrative Mode....................... Disabled
Burned In MAC Address.......................... 00:24:81:D0:0F:C2
Locally Administered MAC address............... 00:00:00:00:00:00
MAC Address Type............................... Burned In
Configured IPv4 Protocol....................... None
Configured IPv6 Protocol....................... None
IPv6 AutoConfig Mode........................... Disabled
Management VLAN ID............................. 1
show serviceport
This command displays service port configuration information.
Management VLAN ID The VLAN ID for the management VLAN. Some network administrators use a
management VLAN to isolate system management traffic from end-user data
traffic.
DHCP Client Identifier The client identifier is displayed in the output of the command only if DHCP is
enabled with the client-id option on the network port. See “network protocol
dhcp” on page 44.
Format
show serviceport
Mode •Privileged EXEC
• User EXEC
Term Definition
Interface Status The network interface status. It is always considered to be up.
IP Address The IP address of the interface. The factory default value is 0.0.0.0.
Subnet Mask The IP subnet mask for this interface. The factory default value is 0.0.0.0.
Default Gateway The default gateway for this IP interface. The factory default value is 0.0.0.0.
IPv6 Administrative
Mode
Whether enabled or disabled. Default value is enabled.
IPv6 Address/Length The IPv6 address and length. Default is Link Local format.
IPv6 Default Router TheIPv6 default router address on the service port. The factory default value is an
unspecified address.
Configured IPv4 Protocol The IPv4 network protocol being used. The options are bootp | dhcp | none.
Configured IPv6 Protocol The IPv6 network protocol being used. The options are dhcp | none.
DHCPv6 Client DUID The DHCPv6 client’s unique client identifier. This row is displayed only when the
configured IPv6 protocol is dhcp.
Term Definition