Command Reference Guide

Denial of Service Commands
CLI Command Reference
September 2014 Page 475
HP Moonshot Switch Module CLI Command Reference
dos-control tcpport
This command enables TCP L4 source = destination port number (Source TCP Port = Destination TCP Port)
Denial of Service protection. If the mode is enabled, Denial of Service prevention is active for this type of
attack. If packets ingress with Source TCP Port = Destination TCP Port, the packets will be dropped if the mode
is enabled.
no dos-control tcpport
This command disables TCP L4 source = destination port number (Source TCP Port = Destination TCP Port)
Denial of Service protection.
dos-control udpport
This command enables UDP L4 source = destination port number (Source UDP Port = Destination UDP Port)
DoS protection. If the mode is enabled, Denial of Service prevention is active for this type of attack. If packets
ingress with Source UDP Port = Destination UDP Port, the packets will be dropped if the mode is enabled.
no dos-control udpport
This command disables UDP L4 source = destination port number (Source UDP Port = Destination UDP Port)
Denial of Service protection.
Default disabled
Format
dos-control tcpport
Mode Global Config
Format
no dos-control tcpport
Mode Global Config
Default disabled
Format
dos-control udpport
Mode Global Config
Format
no dos-control udpport
Mode Global Config