Command Reference Guide

ISDP Commands
CLI Command Reference
September 2014 Page 483
HP Moonshot Switch Module CLI Command Reference
ISDP Commands
This section describes the commands you use to configure the industry standard Discovery Protocol (ISDP).
isdp run
This command enables ISDP on the switch.
no isdp run
This command disables ISDP on the switch.
isdp holdtime
This command configures the hold time for ISDP packets that the switch transmits. The hold time specifies how
long a receiving device should store information sent in the ISDP packet before discarding it. The range is given
in seconds.
isdp timer
This command sets the period of time between sending new ISDP packets. The range is given in seconds.
Default Enabled
Format
isdp run
Mode Global Config
Format
no isdp run
Mode Global Config
Default 180 seconds
Format
isdp holdtime 10-255
Mode Global Config
Default 30 seconds
Format
isdp timer 5-254
Mode Global Config