Command Reference Guide

ISDP Commands
CLI Command Reference
September 2014 Page 487
HP Moonshot Switch Module CLI Command Reference
show isdp entry
This command displays ISDP entries. If the device id is specified, then only entries for that device are shown.
Example: The following shows example CLI display output for the command.
(Routing) #show isdp entry Switch
Device ID Switch
Address(es):
IP Address: 172.20.1.18
IP Address: 172.20.1.18
Capability Router IGMP
Platform cisco WS-C4948
Interface 1/0/1
Port ID GigabitEthernet1/1
Holdtime 64
Advertisement Version 2
Entry last changed time 0 days 00:13:50
Format
show isdp entry {all | deviceid}
Mode Privileged EXEC
Term Definition
Device ID The device ID associated with the neighbor which advertised the information.
IP Addresses The IP address(es) associated with the neighbor.
Capability ISDP Functional Capabilities advertised by the neighbor.
Platform The hardware platform advertised by the neighbor.
Interface The interface (unit/slot/port) on which the neighbor's advertisement was received.
Port ID The port ID of the interface from which the neighbor sent the advertisement.
Hold Time The hold time advertised by the neighbor.
Version The software version that the neighbor is running.
Advertisement
Version
The version of the advertisement packet received from the neighbor.
Entry Last
Changed Time
The time when the entry was last changed.