Command Reference Guide

IPv6 Management Commands
CLI Command Reference
September 2014 Page 49
HP Moonshot Switch Module CLI Command Reference
IPv6 Management Commands
IPv6 Management commands allow a device to be managed via an IPv6 address. HP Moonshot Switch Module
software has capabilities such as:
• Static assignment of IPv6 addresses and gateways for the service/network ports.
• The ability to ping an IPv6 link-local address over the service/network port.
• The ability to send SNMP traps and queries via the service/network port.
• Management of the device via the network port (in addition to a Routing Interface or the Service port).
serviceport ipv6 enable
Use this command to enable IPv6 operation on the service port. By default, IPv6 operation is enabled on the
service port.
no serviceport ipv6 enable
Use this command to disable IPv6 operation on the service port.
network ipv6 enable
Use this command to enable IPv6 operation on the network port. By default, IPv6 operation is enabled on the
network port.
no network ipv6 enable
Use this command to disable IPv6 operation on the network port.
Format
serviceport ipv6 enable
Mode Privileged EXEC
Format
no serviceport ipv6 enable
Mode Privileged EXEC
Format
network ipv6 enable
Mode Privileged EXEC
Format
no network ipv6 enable
Mode Privileged EXEC