Command Reference Guide

UniDirectional Link Detection Commands
CLI Command Reference
September 2014 Page 491
HP Moonshot Switch Module CLI Command Reference
udld reset
This command resets all interfaces that have been shutdown by UDLD.
udld enable (Interface Config)
This command enables UDLD on the specified interface.
no udld enable (Interface Config)
This command disables UDLD on the specified interface.
udld port
This command selects the UDLD mode operating on this interface. If the keyword aggressive is not entered,
the port operates in normal mode.
Default None
Format
udld reset
Mode Privileged EXEC
Default disable
Format
udld enable
Mode Interface Config
Format
no udld enable
Mode Interface Config
Default normal
Format
udld port [aggressive]
Mode Interface Config