Command Reference Guide

IP Routing Commands
CLI Command Reference
September 2014 Page 508
HP Moonshot Switch Module CLI Command Reference
IP Routing Commands
This section describes the commands you use to enable and configure IP routing on the switch.
routing
This command enables IPv4 and IPv6 routing for an interface or range of interfaces. You can view the current
value for this function with the
show ip brief command. The value is labeled as “Routing Mode.”
no routing
This command disables routing for an interface.
You can view the current value for this function with the
show ip brief command. The value is labeled as
“Routing Mode.”
ip routing
This command enables the IP Router Admin Mode for the master switch.
no ip routing
This command disables the IP Router Admin Mode for the master switch.
Default disabled
Format
routing
Mode Interface Config
Format
no routing
Mode Interface Config
Format
ip routing
Mode Global Config
Format
no ip routing
Mode Global Config