Command Reference Guide

IPv6 Management Commands
CLI Command Reference
September 2014 Page 51
HP Moonshot Switch Module CLI Command Reference
serviceport ipv6 gateway
Use this command to configure IPv6 gateway (i.e. Default routers) information for the service port.
no serviceport ipv6 gateway
Use this command to remove IPv6 gateways on the service port interface.
network ipv6 address
Use the options of this command to manually configure IPv6 global address, enable/disable stateless global
address autoconfiguration and to enable/disable dhcpv6 client protocol information for the network port.
Multiple IPv6 addresses can be configured on the network port.
Note: Only a single IPv6 gateway address can be configured for the service port. There may be a
combination of IPv6 prefixes and gateways that are explicitly configured and those that are set
through auto-address configuration with a connected IPv6 router on their service port interface.
Format
serviceport ipv6 gateway gateway-address
Mode Privileged EXEC
Parameter Description
gateway-address Gateway address in IPv6 global or link-local address format.
Format
no serviceport ipv6 gateway
Mode Privileged EXEC
Format
network ipv6 address {address/prefix-length [eui64] | autoconfig | dhcp}
Mode Privileged EXEC
Parameter Description
address IPv6 prefix in IPv6 global address format.
prefix-length IPv6 prefix length value.
eui64 Formulate IPv6 address in eui64 format.
autoconfig Configure stateless global address autoconfiguration capability.
dhcp Configure dhcpv6 client protocol.