Command Reference Guide

IP Routing Commands
CLI Command Reference
September 2014 Page 515
HP Moonshot Switch Module CLI Command Reference
show dhcp lease
This command displays a list of IPv4 addresses currently leased from a DHCP server on a specific in-band
interface or all in-band interfaces. This command does not apply to service or network ports.
show ip brief
This command displays all the summary information of the IP, including the ICMP rate limit configuration and
the global ICMP Redirect configuration.
Note: Routed frames are always ethernet encapsulated when a frame is routed to a VLAN.
Format
show dhcp lease [interface unit/slot/port]
Modes Privileged EXEC
Term Definition
IP address, Subnet mask The IP address and network mask leased from the DHCP server
DHCP Lease server The IPv4 address of the DHCP server that leased the address.
State State of the DHCPv4 Client on this interface
DHCP transaction ID The transaction ID of the DHCPv4 Client
Lease The time (in seconds) that the IP address was leased by the server
Renewal The time (in seconds) when the next DHCP renew Request is sent by DHCPv4
Client to renew the leased IP address
Rebind The time (in seconds) when the DHCP Rebind process starts
Retry count Number of times the DHCPv4 client sends a DHCP REQUEST message before the
server responds
Format
show ip brief
Modes •Privileged EXEC
• User EXEC
Term Definition
Default Time to Live The computed TTL (Time to Live) of forwarding a packet from the local router to the
final destination.
Routing Mode Shows whether the routing mode is enabled or disabled.
Maximum Next Hops The maximum number of next hops the packet can travel.
Maximum Routes The maximum number of routes the packet can travel.
ICMP Rate Limit
Interval
Shows how often the token bucket is initialized with burst-size tokens. Burst-interval
is from 0 to 2147483647 milliseconds. The default burst-interval is 1000 msec.