Command Reference Guide

IP Routing Commands
CLI Command Reference
September 2014 Page 516
HP Moonshot Switch Module CLI Command Reference
Example: The following shows example CLI display output for the command.
(Routing) #show ip brief
Default Time to Live........................... 64
Routing Mode................................... Disabled
Maximum Next Hops.............................. 4
Maximum Routes................................. 128
ICMP Rate Limit Interval....................... 1000 msec
ICMP Rate Limit Burst Size..................... 100 messages
ICMP Echo Replies.............................. Enabled
ICMP Redirects................................. Enabled
show ip interface
This command displays all pertinent information about the IP interface. The argument unit/slot/port
corresponds to a physical routing interface or VLAN routing interface. The keyword vlan is used to specify the
VLAN ID of the routing VLAN directly instead of in a
unit/slot/port format.
ICMP Rate Limit Burst
Size
Shows the number of ICMPv4 error messages that can be sent during one burst-
interval. The range is from 1 to 200 messages. The default value is 100 messages.
ICMP Echo Replies Shows whether ICMP Echo Replies are enabled or disabled.
ICMP Redirects Shows whether ICMP Redirects are enabled or disabled.
Format
show ip interface {unit/slot/port|vlan 1-4093|loopback 0-7}
Modes •Privileged EXEC
• User EXEC
Term Definition
Routing Interface
Status
Determine the operational status of IPv4 routing Interface. The possible values are Up or
Down.
Primary IP
Address
The primary IP address and subnet masks for the interface. This value appears only if you
configure it.
Method Shows whether the IP address was configured manually or acquired from a DHCP server.
Secondary IP
Address
One or more secondary IP addresses and subnet masks for the interface. This value appears
only if you configure it.
Helper IP Address The helper IP addresses configured by the command “ip helper-address (Interface Config)”
on page 549.
Routing Mode The administrative mode of router interface participation. The possible values are enable
or disable. This value is configurable.
Administrative
Mode
The administrative mode of the specified interface. The possible values of this field are
enable or disable. This value is configurable.
Forward Net
Directed
Broadcasts
Displays whether forwarding of network-directed broadcasts is enabled or disabled. This
value is configurable.
Term Definition