Command Reference Guide

IP Routing Commands
CLI Command Reference
September 2014 Page 517
HP Moonshot Switch Module CLI Command Reference
Example: The following shows example CLI display output for the command.
(Routing)#show ip interface 1/0/2
Routing Interface Status....................... Down
Primary IP Address............................. 1.2.3.4/255.255.255.0
Method......................................... Manual
Secondary IP Address(es)....................... 21.2.3.4/255.255.255.0
............................................... 22.2.3.4/255.255.255.0
Helper IP Address.............................. 1.2.3.4
............................................... 1.2.3.5
Routing Mode................................... Disable
Administrative Mode............................ Enable
Forward Net Directed Broadcasts................ Disable
Proxy ARP...................................... Enable
Local Proxy ARP................................ Disable
Active State................................... Inactive
Link Speed Data Rate........................... Inactive
MAC Address.................................... 00:10:18:82:0C:68
Encapsulation Type............................. Ethernet
IP MTU......................................... 1500
Bandwidth...................................... 100000 kbps
Destination Unreachables....................... Enabled
ICMP Redirects................................. Enabled
Example: In the following example the DHCP client is enabled on a VLAN routing interface.
(Routing) #show ip interface vlan 10
Routing Interface Status................. Up
Method................................... DHCP
Routing Mode............................. Enable
Administrative Mode...................... Enable
Proxy ARP Displays whether Proxy ARP is enabled or disabled on the system.
Local Proxy ARP Displays whether Local Proxy ARP is enabled or disabled on the interface.
Active State Displays whether the interface is active or inactive. An interface is considered active if its
link is up and it is in forwarding state.
Link Speed Data
Rate
An integer representing the physical link data rate of the specified interface. This is
measured in Megabits per second (Mbps).
MAC Address The burned in physical address of the specified interface. The format is 6 two-digit
hexadecimal numbers that are separated by colons.
Encapsulation
Type
The encapsulation type for the specified interface. The types are: Ethernet or SNAP.
IP MTU The maximum transmission unit (MTU) size of a frame, in bytes.
Bandwidth Shows the bandwidth of the interface.
Destination
Unreachables
Displays whether ICMP Destination Unreachables may be sent (enabled or disabled).
ICMP Redirects Displays whether ICMP Redirects may be sent (enabled or disabled).
DHCP Client
Identifier
The client identifier is displayed in the output of the command only if DHCP is enabled with
the client-id option on the in-band interface. See “ip address dhcp” on page 510.
Term Definition