Command Reference Guide

IP Routing Commands
CLI Command Reference
September 2014 Page 519
HP Moonshot Switch Module CLI Command Reference
Parameter Description
OSPFv2 Section:
Routing Protocol OSPFv2.
Router ID The router ID configured for OSPFv2.
OSPF Admin
Mode
Whether OSPF is enabled or disabled globally.
Maximum Paths The maximum number of next hops in an OSPF route.
Routing for
Networks
The address ranges configured with an OSPF network command.
Distance The administrative distance (or “route preference”) for intra-area, inter-area, and external
routes.
Default Route
Advertise
Whether OSPF is configured to originate a default route.
Always Whether default advertisement depends on having a default route in the common routing
table.
Metric The metric configured to be advertised with the default route.
Metric Type The metric type for the default route.
Redist Source A type of routes that OSPF is redistributing.
Metric The metric to advertise for redistributed routes of this type.
Metric Type The metric type to advertise for redistributed routes of this type.
Subnets Whether OSPF redistributes subnets of classful addresses, or only classful prefixes.
Dist List A distribute list used to filter routes of this type. Only routes that pass the distribute list are
redistributed.
Number of Active
Areas
The number of OSPF areas with at least one interface running on this router. Also broken
down by area type.
ABR Status Whether the router is currently an area border router. A router is an area border router if
it has interfaces that are up in more than one area.
ASBR Status Whether the router is an autonomous system boundary router. The router is an ASBR if it
is redistributing any routes or originating a default route.
RIP Section
RIP Admin Mode Whether RIP is globally enabled.
Split Horizon
Mode
Whether RIP advertises routes on the interface where they were received.
Default Metric The metric assigned to redistributed routes.
Default Route
Advertise
Whether this router is originating a default route.
Distance The administrative distance for RIP routes.
Redistribution A table showing information for each source protocol (connected, static, and ospf). For
each of these source the distribution list and metric are shown. Fields which are not
configured are left blank. For ospf, configured ospf match parameters are also shown.
Interface The interfaces where RIP is enabled and the version sent and accepted on each interface.