Command Reference Guide

IPv6 Management Commands
CLI Command Reference
September 2014 Page 52
HP Moonshot Switch Module CLI Command Reference
no network ipv6 address
The command no network ipv6 address removes all configured IPv6 prefixes.
Use this command with the address option to remove the manually configured IPv6 global address on the
network port interface.
Use this command with the autoconfig option to disable the stateless global address autoconfiguration on the
network port.
Use this command with the dhcp option disables the dhcpv6 client protocol on the network port.
network ipv6 gateway
Use this command to configure IPv6 gateway (i.e. default routers) information for the network port.
no network ipv6 gateway
Use this command to remove IPv6 gateways on the network port interface.
network ipv6 neighbor
Use this command to manually add IPv6 neighbors to the IPv6 neighbor table for this network port. If an IPv6
neighbor already exists in the neighbor table, the entry is automatically converted to a static entry. Static
entries are not modified by the neighbor discovery process. They are, however, treated the same for IPv6
forwarding. Static IPv6 neighbor entries are applied to the kernel stack and to the hardware when the
corresponding interface is operationally active.
Format
no network ipv6 address {address/prefix-length [eui64] | autoconfig | dhcp}
Mode Privileged EXEC
Format
network ipv6 gateway gateway-address
Mode Privileged EXEC
Parameter Description
gateway-address Gateway address in IPv6 global or link-local address format.
Format
no network ipv6 gateway
Mode Privileged EXEC
Format
network ipv6 neighbor ipv6-address macaddr
Mode Privileged EXEC