Command Reference Guide

IP Routing Commands
CLI Command Reference
September 2014 Page 520
HP Moonshot Switch Module CLI Command Reference
Example: The following shows example CLI display output for the command.
(Router) #show ip protocols
Routing Protocol.......................... OSPFv2
Router ID................................. 6.6.6.6
OSPF Admin Mode........................... Enable
Maximum Paths............................. 32
Routing for Networks...................... 172.24.0.0 0.0.255.255 area 0
10.0.0.0 0.255.255.255 area 1
192.168.75.0 0.0.0.255 area 2
Distance.................................. Intra 110 Inter 110 Ext 110
Default Route Advertise................... Disabled
Always.................................... FALSE
Metric.................................... Not configured
Metric Type............................... External Type 2
Redist
Source Metric Metric Type Subnets Dist List
--------- ------- ----------- ------- ---------
static default 2 Yes None
connected 10 2 Yes 1
Number of Active Areas.................... 3 (3 normal, 0 stub, 0 nssa)
ABR Status................................ Yes
ASBR Status............................... Yes
Routing Protocol.......................... RIP
RIP Admin Mode............................ Enable
Split Horizon Mode........................ Simple
Default Metric............................ Not configured
Default Route Advertise................... Disable
Distance.................................. 120
Redistribution:
Source Metric Dist List Match
--------- ------ --------- --------------------------------------
connected 6
static 10 15
ospf 20 int ext1 ext2 nssa-ext1
Interface Send Recv
--------- ---- ----
0/25 RIPv2 RIPv2