Command Reference Guide

IP Routing Commands
CLI Command Reference
September 2014 Page 523
HP Moonshot Switch Module CLI Command Reference
show ip route ecmp-groups
This command reports all current ECMP groups in the IPv4 routing table. An ECMP group is a set of two or more
next hops used in one or more routes. The groups are numbered arbitrarily from 1 to n. The output indicates
the number of next hops in the group and the number of routes that use the set of next hops. The output lists
the IPv4 address and outgoing interface of each next hop in each group.
Example: The following shows example CLI display output for the command.
(router) #show ip route ecmp-groups
ECMP Group 1 with 2 next hops (used by 1 route)
172.20.33.100 on interface 2/33
172.20.34.100 on interface 2/34
ECMP Group 2 with 3 next hops (used by 1 route)
172.20.32.100 on interface 2/32
172.20.33.100 on interface 2/33
172.20.34.100 on interface 2/34
ECMP Group 3 with 4 next hops (used by 1 route)
172.20.31.100 on interface 2/31
172.20.32.100 on interface 2/32
172.20.33.100 on interface 2/33
172.20.34.100 on interface 2/34
Format
show ip route ecmp-groups
Mode Privileged Exec