Command Reference Guide

Router Discovery Protocol Commands
CLI Command Reference
September 2014 Page 528
HP Moonshot Switch Module CLI Command Reference
Router Discovery Protocol Commands
This section describes the commands you use to view and configure Router Discovery Protocol settings on the
switch. The Router Discovery Protocol enables a host to discover the IP address of routers on the subnet.
ip irdp
This command enables Router Discovery on an interface or range of interfaces.
no ip irdp
This command disables Router Discovery on an interface.
ip irdp address
This command configures the address that the interface uses to send the router discovery advertisements. The
valid values for
ipaddr are 224.0.0.1, which is the all-hosts IP multicast address, and 255.255.255.255, which is
the limited broadcast address.
no ip irdp address
This command configures the default address used to advertise the router for the interface.
Default disabled
Format
ip irdp
Mode Interface Config
Format
no ip irdp
Mode Interface Config
Default 224.0.0.1
Format
ip irdp address ipaddr
Mode Interface Config
Format
no ip irdp address
Mode Interface Config