Command Reference Guide

IPv6 Management Commands
CLI Command Reference
September 2014 Page 53
HP Moonshot Switch Module CLI Command Reference
no network ipv6 neighbor
Use this command to remove IPv6 neighbors from the neighbor table.
show network ipv6 neighbors
Use this command to display the information about the IPv6 neighbor entries cached on the network port. The
information is updated to show the type of the entry.
Example: The following is an example of the command.
(Routing) #show network ipv6 neighbors
Neighbor Age
IPv6 Address MAC Address isRtr State (Secs) Type
------------------------ ----------------- ----- --------- ------ ------
FE80::5E26:AFF:FEBD:852C 5c:26:0a:bd:85:2c FALSE Reachable 0 Static
Parameter Description
ipv6-address The IPv6 address of the neighbor or interface.
macaddr The link-layer address.
Format
no network ipv6 neighbor ipv6-address macaddr
Mode Privileged EXEC
Default None
Format
show network ipv6 neighbors
Mode • Privileged EXEC
Field Description
IPv6 Address The IPv6 address of the neighbor.
MAC Address The MAC Address of the neighbor.
isRtr Shows if the neighbor is a router. If TRUE, the neighbor is a router; FALSE it is not a router.
Neighbor State The state of the neighbor cache entry. Possible values are: Incomplete, Reachable, Stale,
Delay, Probe, and Unknown
Age The time in seconds that has elapsed since an entry was added to the cache.
Last Updated The time in seconds that has elapsed since an entry was added to the cache.
Type The type of neighbor entry. The type is Static if the entry is manually configured and
Dynamic if dynamically resolved.