Command Reference Guide

Router Discovery Protocol Commands
CLI Command Reference
September 2014 Page 531
HP Moonshot Switch Module CLI Command Reference
show ip irdp
This command displays the router discovery information for all interfaces, a specified interface, or specified
VLAN. The argument unit/slot/port corresponds to a physical routing interface or VLAN routing interface. The
keyword vlan is used to specify the VLAN ID of the routing VLAN directly instead of in a unit/slot/port format.
Format
show ip irdp {unit/slot/port|vlan 1-4093|all}
Modes •Privileged EXEC
• User EXEC
Term Definition
Interface The
unit/slot/port that corresponds to a physical routing interface or vlan routing
interface.
vlan Use this keyword to specify the VLAN ID of the routing VLAN directly instead of in a
unit/
slot/port
format.
Ad Mode The advertise mode, which indicates whether router discovery is enabled or disabled on
this interface.
Dest Address The destination IP address for router advertisements.
Max Int The maximum advertise interval, which is the maximum time, in seconds, allowed between
sending router advertisements from the interface.
Min Int The minimum advertise interval, which is the minimum time, in seconds, allowed between
sending router advertisements from the interface.
Hold Time The amount of time, in seconds, that a system should keep the router advertisement
before discarding it.
Preference The preference of the address as a default router address, relative to other router
addresses on the same subnet.