Command Reference Guide

Virtual Router Redundancy Protocol Commands
CLI Command Reference
September 2014 Page 535
HP Moonshot Switch Module CLI Command Reference
Virtual Router Redundancy Protocol Commands
This section describes the commands you use to view and configure Virtual Router Redundancy Protocol
(VRRP) and to view VRRP status information. VRRP helps provide failover and load balancing when you
configure two devices as a VRRP pair.
ip vrrp (Global Config)
Use this command in Global Config mode to enable the administrative mode of VRRP on the router.
no ip vrrp
Use this command in Global Config mode to disable the default administrative mode of VRRP on the router.
ip vrrp (Interface Config)
Use this command in Interface Config mode to create a virtual router associated with the interface or range of
interfaces. The parameter
vrid is the virtual router ID, which has an integer value range from 1 to 255.
no ip vrrp
Use this command in Interface Config mode to delete the virtual router associated with the interface. The
virtual Router ID,
vrid, is an integer value that ranges from 1 to 255.
Default none
Format
ip vrrp
Mode Global Config
Format
no ip vrrp
Mode Global Config
Format
ip vrrp vrid
Mode Interface Config
Format
no ip vrrp vrid
Mode Interface Config