Command Reference Guide

Virtual Router Redundancy Protocol Commands
CLI Command Reference
September 2014 Page 536
HP Moonshot Switch Module CLI Command Reference
ip vrrp mode
This command enables the virtual router configured on the specified interface. Enabling the status field starts
a virtual router. The parameter
vrid is the virtual router ID which has an integer value ranging from 1 to 255.
no ip vrrp mode
This command disables the virtual router configured on the specified interface. Disabling the status field stops
a virtual router.
ip vrrp ip
This command sets the virtual router IP address value for an interface or range of interfaces. The value for
ipaddr is the IP address which is to be configured on that interface for VRRP. The parameter vrid is the virtual
router ID which has an integer value range from 1 to 255. You can use the optional
[secondary] parameter to
designate the IP address as a secondary IP address.
no ip vrrp ip
Use this command in Interface Config mode to delete a secondary IP address value from the interface. To delete
the primary IP address, you must delete the virtual router on the interface.
Default disabled
Format
ip vrrp vrid mode
Mode Interface Config
Format
no ip vrrp vrid mode
Mode Interface Config
Default none
Format
ip vrrp vrid ip ipaddr [secondary]
Mode Interface Config
Format
no ip vrrp vrid ipaddress secondary
Mode Interface Config