Command Reference Guide

Virtual Router Redundancy Protocol Commands
CLI Command Reference
September 2014 Page 540
HP Moonshot Switch Module CLI Command Reference
no ip vrrp track interface
Use this command to remove the interface or range of interfaces from the tracked list or to restore the priority
decrement to its default.
ip vrrp track ip route
Use this command to track the route reachability on an interface or range of interfaces. When the tracked route
is deleted, the priority of the VRRP router will be decremented by the value specified in the
priority argument.
When the tracked route is added, the priority will be incremented by the same.
A VRRP configured interface can track more than one route. When a tracked route goes down, then the priority
of the router will be decreased by 10 (the default priority decrement) for each downed route. By default no
routes are tracked. If you specify just the route to be tracked, without giving the optional priority, then the
default priority will be set. The default priority decrement is 10. The default priority decrement is changed
using the
priority argument.
no ip vrrp track ip route
Use this command to remove the route from the tracked list or to restore the priority decrement to its default.
When removing a tracked IP route from the tracked list, the priority should be incremented by the decrement
value if the route is not reachable.
Format
no ip vrrp vrid track interface {unit/slot/port|vlan 1-4093} [decrement]
Mode Interface Config
Default priority: 10
Format
ip vrrp vrid track ip route ip-address/prefix-length [decrement priority]
Mode Interface Config
Format
no ip vrrp vrid track interface unit/slot/port [decrement]
Mode Interface Config