Command Reference Guide

Virtual Router Redundancy Protocol Commands
CLI Command Reference
September 2014 Page 542
HP Moonshot Switch Module CLI Command Reference
show ip vrrp
This command displays whether VRRP functionality is enabled or disabled on the switch. It also displays some
global parameters which are required for monitoring. This command takes no options.
show ip vrrp interface
This command displays all configuration information and VRRP router statistics of a virtual router configured
on a specific interface. The argument unit/slot/port corresponds to a physical routing interface or VLAN routing
interface. The keyword vlan is the VLAN ID of the routing VLAN instead of in a unit/slot/port format. Use the
output of the command to verify the track interface and track IP route configurations.
Format
show ip vrrp
Modes •Privileged EXEC
• User EXEC
Term Definition
VRRP Admin Mode The administrative mode for VRRP functionality on the switch.
Router Checksum Errors The total number of VRRP packets received with an invalid VRRP checksum value.
Router Version Errors The total number of VRRP packets received with Unknown or unsupported version
number.
Router VRID Errors The total number of VRRP packets received with invalid VRID for this virtual router.
Format
show ip vrrp interface {unit/slot/port|vlan 1-4093} vrid
Modes •Privileged EXEC
• User EXEC
Term Definition
IP Address The configured IP address for the Virtual router.
VMAC address The VMAC address of the specified router.
Authentication type The authentication type for the specific virtual router.
Priority The priority value for the specific virtual router, taking into account any priority
decrements for tracked interfaces or routes.
Configured Priority The priority configured through the
ip vrrp vrid priority 1-254 command.
Advertisement interval The advertisement interval in seconds for the specific virtual router.
Pre-Empt Mode The preemption mode configured on the specified virtual router.
Administrative Mode The status (Enable or Disable) of the specific router.
Accept Mode When enabled, the VRRP Master can accept ping packets sent to one of the
virtual router’s IP addresses.
State The state (Master/backup) of the virtual router.