Command Reference Guide

Virtual Router Redundancy Protocol Commands
CLI Command Reference
September 2014 Page 543
HP Moonshot Switch Module CLI Command Reference
Example: The following shows example CLI display output for the command.
show ip vrrp interface <u/s/p> vrid
Primary IP Address............................. 1.1.1.5
VMAC Address................................... 00:00:5e:00:01:01
Authentication Type............................ None
Priority....................................... 80
Configured priority.......................... 100
Advertisement Interval (secs).................. 1
Pre-empt Mode.................................. Enable
Administrative Mode............................ Enable
Accept Mode.................................... Enable
State.......................................... Initialized
Track Interface State DecrementPriority
--------------- ------ ------------------
<1/0/1> down 10
TrackRoute (pfx/len) State DecrementPriority
------------------------ ------ ------------------
10.10.10.1/255.255.255.0 down 10
show ip vrrp interface brief
This command displays information about each virtual router configured on the switch. This command takes
no options. It displays information about each virtual router.
Format
show ip vrrp interface brief
Modes •Privileged EXEC
• User EXEC
Term Definition
Interface unit/slot/port
VRID The router ID of the virtual router.
IP Address The virtual router IP address.
Mode Indicates whether the virtual router is enabled or disabled.
State The state (Master/backup) of the virtual router.