Command Reference Guide

DHCP and BOOTP Relay Commands
CLI Command Reference
September 2014 Page 544
HP Moonshot Switch Module CLI Command Reference
DHCP and BOOTP Relay Commands
This section describes the commands you use to configure BootP/DHCP Relay on the switch. A DHCP relay
agent operates at Layer 3 and forwards DHCP requests and replies between clients and servers when they are
not on the same physical subnet.
bootpdhcprelay cidoptmode
This command enables the circuit ID option mode for BootP/DHCP Relay on the system.
no bootpdhcprelay cidoptmode
This command disables the circuit ID option mode for BootP/DHCP Relay on the system.
bootpdhcprelay maxhopcount
This command configures the maximum allowable relay agent hops for BootP/DHCP Relay on the system. The
hops parameter has a range of 1 to 16.
no bootpdhcprelay maxhopcount
This command configures the default maximum allowable relay agent hops for BootP/DHCP Relay on the
system.
Default disabled
Format
bootpdhcprelay cidoptmode
Mode Global Config
Format
no bootpdhcprelay cidoptmode
Mode Global Config
Default 4
Format
bootpdhcprelay maxhopcount 1-16
Mode Global Config
Format
no bootpdhcprelay maxhopcount
Mode Global Config