Command Reference Guide

Open Shortest Path First Commands
CLI Command Reference
September 2014 Page 555
HP Moonshot Switch Module CLI Command Reference
Open Shortest Path First Commands
This section describes the commands you use to view and configure Open Shortest Path First (OSPF), which is
a link-state routing protocol that you use to route traffic within a network. This section contains the following
subsections:
• “General OSPF Commands” on page 555
• “OSPF Interface Commands” on page 575
• “IP Event Dampening Commands” on page 581
• “OSPFv2 Stub Router Commands” on page 586
• “OSPF Show Commands” on page 587
General OSPF Commands
router ospf
Use this command to enter Router OSPF mode.
enable (OSPF)
This command resets the default administrative mode of OSPF in the router (active).
no enable (OSPF)
This command sets the administrative mode of OSPF in the router to inactive.
Format
router ospf
Mode Global Config
Default enabled
Format
enable
Mode Router OSPF Config
Format
no enable
Mode Router OSPF Config