Command Reference Guide

Open Shortest Path First Commands
CLI Command Reference
September 2014 Page 556
HP Moonshot Switch Module CLI Command Reference
network area (OSPF)
Use this command to enable OSPFv2 on an interface and set its area ID if the IP address of an interface is
covered by this network command.
no network area (OSPF)
Use this command to disable the OSPFv2 on a interface if the IP address of an interface was earlier covered by
this network command.
1583compatibility
This command enables OSPF 1583 compatibility.
no 1583compatibility
This command disables OSPF 1583 compatibility.
area default-cost (OSPF)
This command configures the default cost for the stub area. You must specify the area ID and an integer value
between 1-16777215.
Default disabled
Format
network ip-address wildcard-mask area area-id
Mode Router OSPF Config
Format
no network ip-address wildcard-mask area area-id
Mode Router OSPF Config
Note: 1583 compatibility mode is enabled by default. If all OSPF routers in the routing domain are
capable of operating according to RFC 2328, OSPF 1583 compatibility mode should be disabled.
Default enabled
Format
1583compatibility
Mode Router OSPF Config
Format
no 1583compatibility
Mode Router OSPF Config
Format
area areaid default-cost 1-16777215
Mode Router OSPF Config