Command Reference Guide

Open Shortest Path First Commands
CLI Command Reference
September 2014 Page 562
HP Moonshot Switch Module CLI Command Reference
no area virtual-link
This command deletes the OSPF virtual interface from the given interface, identified by areaid and neighbor.
The
neighbor parameter is the Router ID of the neighbor.
area virtual-link authentication
This command configures the authentication type and key for the OSPF virtual interface identified by areaid
and
neighbor. The neighbor parameter is the Router ID of the neighbor. The value for type is either none,
simple, or encrypt. The
key is composed of standard displayable, non-control keystrokes from a Standard 101/
102-key keyboard. The authentication key must be 8 bytes or less if the authentication type is simple. If the
type is encrypt, the key may be up to 16 bytes. Unauthenticated interfaces do not need an authentication key.
If the type is encrypt, a key id in the range of 0 and 255 must be specified.The default value for authentication
type is none. Neither the default password key nor the default key id are configured.
no area virtual-link authentication
This command configures the default authentication type for the OSPF virtual interface identified by areaid
and
neighbor. The neighbor parameter is the Router ID of the neighbor.
area virtual-link dead-interval (OSPF)
This command configures the dead interval for the OSPF virtual interface on the virtual interface identified by
areaid and neighbor. The neighbor parameter is the Router ID of the neighbor. The range for seconds is 1 to
65535.
Format
no area areaid virtual-link neighbor
Mode Router OSPF Config
Default none
Format
area areaid virtual-link neighbor authentication {none | {simple key} | {encrypt key
keyid}}
Mode Router OSPF Config
Format
no area areaid virtual-link neighbor authentication
Mode Router OSPF Config
Default 40
Format
area areaid virtual-link neighbor dead-interval seconds
Mode Router OSPF Config