Command Reference Guide

Open Shortest Path First Commands
CLI Command Reference
September 2014 Page 565
HP Moonshot Switch Module CLI Command Reference
capability opaque
Use this command to enable Opaque Capability on the Router. The information contained in Opaque LSAs may
be used directly by OSPF or indirectly by an application wishing to distribute information throughout the OSPF
domain. The HP Moonshot Switch Module supports the storing and flooding of Opaque LSAs of different
scopes. The default value of
enabled means that OSPF will forward opaque LSAs by default. If you want to
upgrade from a previous release, where the default was disabled, opaque LSA forwarding will be enabled. If
you want to disable opaque LSA forwarding, then you should enter the command no capability opaque in OSPF
router configuration mode after the software upgrade.
no capability opaque
Use this command to disable opaque capability on the router.
clear ip ospf
Use this command to disable and re-enable OSPF.
clear ip ospf configuration
Use this command to reset the OSPF configuration to factory defaults.
clear ip ospf counters
Use this command to reset global and interface statistics.
Default enabled
Format
capability opaque
Mode Router Config
Format
no capability opaque
Mode Router Config
Format
clear ip ospf
Mode Privileged EXEC
Format
clear ip ospf configuration
Mode Privileged EXEC
Format
clear ip ospf counters
Mode Privileged EXEC