Command Reference Guide

Open Shortest Path First Commands
CLI Command Reference
September 2014 Page 568
HP Moonshot Switch Module CLI Command Reference
exit-overflow-interval (OSPF)
This command configures the exit overflow interval for OSPF. It describes the number of seconds after entering
overflow state that a router will wait before attempting to leave the overflow state. This allows the router to
again originate non-default AS-external-LSAs. When set to 0, the router will not leave overflow state until
restarted. The range for seconds is 0 to 2147483647 seconds.
no exit-overflow-interval
This command configures the default exit overflow interval for OSPF.
external-lsdb-limit (OSPF)
This command configures the external LSDB limit for OSPF. If the value is -1, then there is no limit. When the
number of non-default AS-external-LSAs in a router's link-state database reaches the external LSDB limit, the
router enters overflow state. The router never holds more than the external LSDB limit non-default AS-
external-LSAs in it database. The external LSDB limit MUST be set identically in all routers attached to the OSPF
backbone and/or any regular OSPF area. The range for limit is -1 to 2147483647.
no external-lsdb-limit
This command configures the default external LSDB limit for OSPF.
Default 0
Format
exit-overflow-interval seconds
Mode Router OSPF Config
Format
no exit-overflow-interval
Mode Router OSPF Config
Default -1
Format
external-lsdb-limit limit
Mode Router OSPF Config
Format
no external-lsdb-limit
Mode Router OSPF Config