Command Reference Guide

Open Shortest Path First Commands
CLI Command Reference
September 2014 Page 570
HP Moonshot Switch Module CLI Command Reference
no redistribute
This command configures OSPF protocol to prohibit redistribution of routes from the specified source
protocol/routers.
maximum-paths (OSPF)
This command sets the number of paths that OSPF can report for a given destination where maxpaths is 1–4.
no maximum-paths
This command resets the number of paths that OSPF can report for a given destination back to its default value.
passive-interface default (OSPF)
Use this command to enable global passive mode by default for all interfaces. It overrides any interface level
passive mode. OSPF will not form adjacencies over a passive interface.
no passive-interface default
Use this command to disable the global passive mode by default for all interfaces. Any interface previously
configured to be passive reverts to non-passive mode.
Format
no redistribute {rip | static | connected} [metric] [metric-type] [tag] [subnets]
Mode Router OSPF Config
Default 4
Format
maximum-paths maxpaths
Mode Router OSPF Config
Format
no maximum-paths
Mode Router OSPF Config
Default disabled
Format
passive-interface default
Mode Router OSPF Config
Format
no passive-interface default
Mode Router OSPF Config