Command Reference Guide

Open Shortest Path First Commands
CLI Command Reference
September 2014 Page 577
HP Moonshot Switch Module CLI Command Reference
no ip ospf database-filter all out
Use the no ip ospf database-filter all out command in Interface Configuration mode to enable OSPFv2 LSA
flooding on an interface.
ip ospf dead-interval
This command sets the OSPF dead interval for the specified interface or range of interfaces. The value for
seconds (range: 1–65535), which represents the length of time in seconds that a router's Hello packets have
not been seen before its neighbor routers declare that the router is down. The value for the length of time must
be the same for all routers attached to a common network. This value should be some multiple of the Hello
Interval (i.e. 4).
no ip ospf dead-interval
This command sets the default OSPF dead interval for the specified interface.
ip ospf hello-interval
This command sets the OSPF hello interval for the specified interface or range of interfaces. The value for
seconds is a valid positive integer, which represents the length of time in seconds. The value for the length of
time must be the same for all routers attached to a network. Valid values range from 1 to 65535.
no ip ospf hello-interval
This command sets the default OSPF hello interval for the specified interface.
Default Disabled
Format
ip ospf database-filter all out
Mode Interface Configuration
Default 40
Format
ip ospf dead-interval seconds
Mode Interface Config
Format
no ip ospf dead-interval
Mode Interface Config
Default 10
Format
ip ospf hello-interval seconds
Mode Interface Config
Format
no ip ospf hello-interval
Mode Interface Config