Command Reference Guide

Console Port Access Commands
CLI Command Reference
September 2014 Page 59
HP Moonshot Switch Module CLI Command Reference
DHCPv6 Solicit Packets Transmitted.................... 0
DHCPv6 Request Packets Transmitted.................... 0
DHCPv6 Renew Packets Transmitted...................... 0
DHCPv6 Rebind Packets Transmitted..................... 0
DHCPv6 Release Packets Transmitted.................... 0
Total DHCPv6 Packets Transmitted...................... 0
clear network ipv6 dhcp statistics
Use this command to clear the DHCPv6 statistics on the network management interface.
clear serviceport ipv6 dhcp statistics
Use this command to clear the DHCPv6 client statistics on the service port interface.
Console Port Access Commands
This section describes the commands you use to configure the console port. You can use a serial cable to
connect a management host directly to the console port of the switch.
configuration
This command gives you access to the Global Config mode. From the Global Config mode, you can configure a
variety of system settings, including user accounts. From the Global Config mode, you can enter other
command modes, including Line Config mode.
line
This command gives you access to the Line Console mode, which allows you to configure various Telnet settings
and the console port, as well as to configure console login/enable authentication.
Format
clear network ipv6 dhcp statistics
Mode Privileged EXEC
Format
clear serviceport ipv6 dhcp statistics
Mode Privileged EXEC
Format
configuration
Mode Privileged EXEC
Format
line {console | telnet | ssh}
Mode Global Config