Command Reference Guide

Open Shortest Path First Commands
CLI Command Reference
September 2014 Page 593
HP Moonshot Switch Module CLI Command Reference
Example: The following shows example CLI display output for the command.
(R1) #show ip ospf area 1
AreaID......................................... 0.0.0.1
External Routing............................... Import External LSAs
Spf Runs....................................... 10
Area Border Router Count....................... 0
Area LSA Count................................. 3004
Area LSA Checksum.............................. 0x5e0abed
Flood List Length.............................. 0
Import Summary LSAs............................ Enable
show ip ospf asbr
This command displays the internal OSPF routing table entries to Autonomous System Boundary Routers
(ASBR). This command takes no options.
show ip ospf database
This command displays information about the link state database when OSPF is enabled. If you do not enter
any parameters, the command displays the LSA headers for all areas. Use the optional
areaid parameter to
display database information about a specific area. Use the optional parameters to specify the type of link state
advertisements to display.
Format
show ip ospf asbr
Mode •Privileged EXEC
• User EXEC
Term Definition
Type The type of the route to the destination. It can be one of the following values:
intra — Intra-area route
inter — Inter-area route
Router ID Router ID of the destination.
Cost Cost of using this route.
Area ID The area ID of the area from which this route is learned.
Next Hop Next hop toward the destination.
Next Hop Intf The outgoing router interface to use when forwarding traffic to the next hop.
Parameter Description
asbr-summary Use
asbr-summary to show the autonomous system boundary router (ASBR) summary LSAs.
external Use
external to display the external LSAs.
network Use
network to display the network LSAs.
nssa-external Use
nssa-external to display NSSA external LSAs.