Command Reference Guide

Open Shortest Path First Commands
CLI Command Reference
September 2014 Page 596
HP Moonshot Switch Module CLI Command Reference
The information below will only be displayed if OSPF is enabled.
Example: The following shows example CLI display output for the command when the OSPF Admin Mode
is disabled.
(Routing) >show ip ospf interface 1/0/1
IP Address..................................... 0.0.0.0
Subnet Mask.................................... 0.0.0.0
Secondary IP Address(es).......................
OSPF Admin Mode................................ Disable
OSPF Area ID................................... 0.0.0.0
OSPF Network Type.............................. Broadcast
Router Priority................................ 1
Retransmit Interval............................ 5
Hello Interval................................. 10
Dead Interval.................................. 40
LSA Ack Interval............................... 1
Transmit Delay................................. 1
Router Priority A number representing the OSPF Priority for the specified interface.
Retransmit Interval A number representing the OSPF Retransmit Interval for the specified interface.
Hello Interval A number representing the OSPF Hello Interval for the specified interface.
Dead Interval A number representing the OSPF Dead Interval for the specified interface.
LSA Ack Interval A number representing the OSPF LSA Acknowledgment Interval for the specified
interface.
Transmit Delay A number representing the OSPF Transmit Delay Interval for the specified interface.
Authentication Type The OSPF Authentication Type for the specified interface are: none, simple, and
encrypt.
Metric Cost The cost of the OSPF interface.
Passive Status Shows whether the interface is passive or not.
OSPF MTU-ignore Indicates whether to ignore MTU mismatches in database descriptor packets sent
from neighboring routers.
Flood Blocking Indicates whether flood blocking is enabled on the interface.
Term Definition
OSPF Interface Type Broadcast LANs, such as Ethernet and IEEE 802.5, take the value
broadcast. The
OSPF Interface Type will be 'broadcast'.
State The OSPF Interface States are: down, loopback, waiting, point-to-point,
designated router, and backup designated router.
Designated Router The router ID representing the designated router.
Backup Designated Router The router ID representing the backup designated router.
Number of Link Events The number of link events.
Local Link LSAs The number of Link Local Opaque LSAs in the link-state database.
Local Link LSA Checksum The sum of LS Checksums of Link Local Opaque LSAs in the link-state database.
Term Definition