Command Reference Guide

Open Shortest Path First Commands
CLI Command Reference
September 2014 Page 604
HP Moonshot Switch Module CLI Command Reference
00:05:15 0 10 0 10 0 R, N, SN
00:05:11 0 0 0 0 0 R
00:04:50 0 60 0 60 460 R, N
00:04:46 0 90 0 100 60 R, N
00:03:42 0 70 10 90 160 R
00:03:39 0 70 40 120 240 X
00:03:36 0 60 60 130 160 X
00:01:28 0 60 50 130 240 X
00:01:25 0 30 50 110 310 SN
00:01:22 0 0 40 50 260 SN
00:01:19 0 0 20 20 190 X
00:01:16 0 0 0 0 110 R, X
show ip ospf stub table
This command displays the OSPF stub table. The information below will only be displayed if OSPF is initialized
on the switch.
show ip ospf traffic
This command displays OSPFv2 packet and LSA statistics and OSPFv2 message queue statistics. Packet statistics
count packets and LSAs since OSPFv2 counters were last cleared (using the command “clear ip ospf counters”
on page 565).
Format
show ip ospf stub table
Modes •Privileged EXEC
• User EXEC
Term Definition
Area ID A 32-bit identifier for the created stub area.
Type of Service The type of service associated with the stub metric. HP Moonshot Switch Module software
only supports Normal TOS.
Metric Val The metric value is applied based on the TOS. It defaults to the least metric of the type of
service among the interfaces to other areas. The OSPF cost for a route is a function of the
metric value.
Import Summary
LSA
Controls the import of summary LSAs into stub areas.
Note: The “clear ip ospf counters” command does not clear the message queue high water marks.
Format
show ip ospf traffic
Modes Privileged EXEC