Command Reference Guide

Routing Information Protocol Commands
CLI Command Reference
September 2014 Page 607
HP Moonshot Switch Module CLI Command Reference
Routing Information Protocol Commands
This section describes the commands you use to view and configure Routing Information Protocol (RIP), which
is a distance-vector routing protocol that you use to route traffic within a small network.
router rip
Use this command to enter Router RIP mode.
enable (RIP)
This command resets the default administrative mode of RIP in the router (active).
no enable (RIP)
This command sets the administrative mode of RIP in the router to inactive.
ip rip
This command enables RIP on a router interface or range of interfaces.
no ip rip
This command disables RIP on a router interface.
Format
router rip
Mode Global Config
Default enabled
Format
enable
Mode Router RIP Config
Format
no enable
Mode Router RIP Config
Default disabled
Format
ip rip
Mode Interface Config
Format
no ip rip
Mode Interface Config