Command Reference Guide

ICMP Throttling Commands
CLI Command Reference
September 2014 Page 614
HP Moonshot Switch Module CLI Command Reference
The following information will be invalid if the link state is down.
ICMP Throttling Commands
This section describes the commands you use to configure options for the transmission of various types of
ICMP messages.
ip unreachables
Use this command to enable the generation of ICMP Destination Unreachable messages on an interface or
range of interfaces. By default, the generation of ICMP Destination Unreachable messages is enabled.
no ip unreachables
Use this command to prevent the generation of ICMP Destination Unreachable messages.
ip redirects
Use this command to enable the generation of ICMP Redirect messages by the router. By default, the
generation of ICMP Redirect messages is enabled. You can use this command to configure an interface, a range
of interfaces, or all interfaces.
Term Definition
Bad Packets
Received
The number of RIP response packets received by the RIP process which were subsequently
discarded for any reason.
Bad Routes
Received
The number of routes contained in valid RIP packets that were ignored for any reason.
Updates Sent The number of triggered RIP updates actually sent on this interface.
Default enable
Format
ip unreachables
Mode Interface Config
Format
no ip unreachables
Mode Interface Config
Default enable
Format
ip redirects
Mode • Global Config
•Interface Config