Command Reference Guide

Loopback Interface Commands
CLI Command Reference
September 2014 Page 616
HP Moonshot Switch Module CLI Command Reference
no ip icmp error-interval
Use the no form of the command to return burst-interval and burst-size to their default values.
Loopback Interface Commands
The commands in this section describe how to create, delete, and manage loopback interfaces. A loopback
interface is always expected to be up. This interface can provide the source address for sent packets and can
receive both local and remote packets. The loopback interface is typically used by routing protocols.
To assign an IP address to the loopback interface, see “ip address” on page 509.
interface loopback
Use this command to enter the Interface Config mode for a loopback interface. The range of the loopback ID is
0 to 7.
no interface loopback
This command removes the loopback interface and associated configuration parameters for the specified
loopback interface.
Format
no ip icmp error-interval
Mode Global Config
Format
interface loopback loopback-id
Mode Global Config
Format
no interface loopback loopback-id
Mode Global Config