Command Reference Guide

Loopback Interface Commands
CLI Command Reference
September 2014 Page 617
HP Moonshot Switch Module CLI Command Reference
show interface loopback
This command displays information about configured loopback interfaces.
If you do not specify a loopback ID, the following information appears for each loopback interface on the
system:
If you specify a loopback ID, the following information appears:
Format
show interface loopback [loopback-id]
Mode Privileged EXEC
Term Definition
Loopback ID The loopback ID associated with the rest of the information in the row.
Interface The interface name.
IP Address The IPv4 address of the interface (if configured).
Term Definition
Interface Link
Status
Shows whether the link is up or down.
IP Address The IPv4 address of the interface.
MTU size The maximum transmission size for packets on this interface, in bytes.