Command Reference Guide

Class of Service Commands
CLI Command Reference
September 2014 Page 620
HP Moonshot Switch Module CLI Command Reference
classofservice trust
This command sets the class of service trust mode of an interface or range of interfaces. You can set the mode
to trust one of the Dot1p (802.1p) or IP DSCP packet markings. You can also set the interface mode to
untrusted. If you configure an interface to use Dot1p, the mode does not appear in the output of the
show
running config
command because Dot1p is the default.
no classofservice trust
This command sets the interface mode to the default value.
cos-queue min-bandwidth
This command specifies the minimum transmission bandwidth guarantee for each interface queue on an
interface, a range of interfaces, or all interfaces. The total number of queues supported per interface is 7. A
value from 0–100 (percentage of link rate) must be specified for each supported queue, with 0 indicating no
guaranteed minimum bandwidth. The sum of all values entered must not exceed 100.
no cos-queue min-bandwidth
This command restores the default for each queue's minimum bandwidth value.
Note: The classofservice trust dot1p command will not be supported in future releases of the
software because Dot1p is the default value. Use the
no classofservice trust command to set the
mode to the default value.
Default dot1p
Format
classofservice trust {dot1p | ip-dscp | untrusted}
Modes • Global Config
•Interface Config
Format
no classofservice trust
Modes • Global Config
•Interface Config
Format
cos-queue min-bandwidth bw-0 bw-1 … bw-n
Modes • Global Config
•Interface Config
Format
no cos-queue min-bandwidth
Modes • Global Config
•Interface Config