Command Reference Guide

Class of Service Commands
CLI Command Reference
September 2014 Page 623
HP Moonshot Switch Module CLI Command Reference
no random-detect queue-parms
Use this command to set the WRED configuration back to the default.
traffic-shape
This command specifies the maximum transmission bandwidth limit for the interface as a whole. The
bandwidth values are from 0-100 in increments of 1. You can also specify this value for a range of interfaces or
all interfaces. Also known as rate shaping, traffic shaping has the effect of smoothing temporary traffic bursts
over time so that the transmitted traffic rate is bounded.
no traffic-shape
This command restores the interface shaping rate to the default value.
show classofservice dot1p-mapping
This command displays the current Dot1p (802.1p) priority mapping to internal traffic classes for a specific
interface. The
unit/slot/port parameter is optional. If specified, the 802.1p mapping table of the interface is
displayed. If omitted, the most recent global configuration settings are displayed.
drop-probability The percentage probability that WRED will mark/drop a packet, when the queue depth is
at the maximum threshold. (The drop probability increases linearly from 0 just before the
minimum threshold, to this value at the maximum threshold, then goes to 100% for larger
queue depths).
Format
no random-detect queue-parms queue-id-1 [queue-id-2 … queue-id-n]
Modes • Global Config
•Interface Config
Format
traffic-shape bw
Modes • Global Config
•Interface Config
Format
no traffic-shape
Modes • Global Config
•Interface Config
Format
show classofservice dot1p-mapping [unit/slot/port]
Mode • User EXEC
•Privileged EXEC
Term Definition