Command Reference Guide

Class of Service Commands
CLI Command Reference
September 2014 Page 624
HP Moonshot Switch Module CLI Command Reference
The following information is repeated for each user priority.
show classofservice ip-dscp-mapping
This command displays the current IP DSCP mapping to internal traffic classes for the global configuration
settings.
The following information is repeated for each user priority.
show classofservice trust
This command displays the current trust mode setting for a specific interface. The unit/slot/port parameter
is optional. If you specify an interface, the command displays the port trust mode of the interface. If you do not
specify an interface, the command displays the most recent global configuration settings.
Term Definition
User Priority The 802.1p user priority value.
Traffic Class The traffic class internal queue identifier to which the user priority value is mapped.
Format
show classofservice ip-dscp-mapping
Mode Privileged EXEC
Term Definition
IP DSCP The IP DSCP value.
Traffic Class The traffic class internal queue identifier to which the IP DSCP value is mapped.
Format
show classofservice trust [unit/slot/port]
Mode Privileged EXEC
Note: The output that displays depends on the configured trust mode.
Term Definition
Class of Service Trust
Mode
The the trust mode, which is either Dot1P, IP DSCP, or Untrusted.
Non-IP Traffic Class (IP DSCP mode only) The traffic class used for non-IP traffic.
Untrusted Traffic Class (Untrusted mode only) The traffic class used for all untrusted traffic.