Command Reference Guide

Telnet Commands
CLI Command Reference
September 2014 Page 63
HP Moonshot Switch Module CLI Command Reference
transport input telnet
This command regulates new Telnet sessions. If enabled, new Telnet sessions can be established until there are
no more sessions available. An established session remains active until the session is ended or an abnormal
network error ends the session.
no transport input telnet
Use this command to prevent new Telnet sessions from being established.
transport output telnet
This command regulates new outbound Telnet connections. If enabled, new outbound Telnet sessions can be
established until the system reaches the maximum number of simultaneous outbound Telnet sessions allowed.
An established session remains active until the session is ended or an abnormal network error ends it.
no transport output telnet
Use this command to prevent new outbound Telnet connection from being established.
Note: If the Telnet Server Admin Mode is disabled, Telnet sessions cannot be established. Use the ip
telnet server enable
command to enable Telnet Server Admin Mode.
Default enabled
Format
transport input telnet
Mode Line Config
Format
no transport input telnet
Mode Line Config
Default enabled
Format
transport output telnet
Mode Line Config
Format
no transport output telnet
Mode Line Config