Command Reference Guide

DiffServ Class Commands
CLI Command Reference
September 2014 Page 630
HP Moonshot Switch Module CLI Command Reference
match ethertype
This command adds to the specified class definition a match condition based on the value of the ethertype.
The
ethertype value is specified as one of the following keywords: appletalk, arp, ibmsna, ipv4, ipv6, ipx,
mplsmcast, mplsucast, netbios, novell, pppoe, rarp or as a custom EtherType value in the range of 0x0600-
0xFFFF.
match any
This command adds to the specified class definition a match condition whereby all packets are considered to
belong to the class.
match class-map
This command adds to the specified class definition the set of match conditions defined for another class. The
refclassname is the name of an existing DiffServ class whose match conditions are being referenced by the
specified class definition.
Format
match ethertype {keyword | custom 0x0600-0xFFFF}
Mode Class-Map Config
Ipv6-Class-Map Config
Default none
Format
match any
Mode Class-Map Config
Ipv6-Class-Map Config
Default
none
Format
match class-map refclassname
Mode Class-Map Config
Ipv6-Class-Map Config